Home


Pharmacies
Online Pricing
Info
About Impotence
Viagra
FAQ
Using Rejoyn Products
Resources
e-mail us
Phone and Address

Rejoyn Vacuum Therapy System | Rejoyn Support Sleeve
Rejoyn Support Ring
| Endure Climax Control Sleeve

Rejoyn Vacuum Therapy System

How to Use the Vacuum PumpThe patented vacuum therapy system allows a man to achieve a firm, natural erection. The technique works by placing a vacuum over the penis and drawing blood into the penis to create an erection. A constriction ring is placed around the base of the penis, gently providing pressure to help maintain an erection until you remove it.

Steps to prepare the Rejoyn Vacuum Therapy System for use:

1. Twist the tube clockwise onto the pumphead, locking it in place.
NOTE: Before attaching the pumphead run warm water over the tube. This will help to prevent the tube from fogging over during use.
2. Set the pumphead on a flat surface with the open end pointing up. Install the cone in the penile tube.
3. Lubricate the surface of the cone, grasp the two tabs of the ring and push the ring down, using both thumbs, over the cone onto the penile tube.
NOTE: Start with the largest constriction ring. If you are unable to hold the erection with the larger ring, gradually use the next smallest constriction ring until the ring is able to hold the erection.
4. Remove cone from penile tube, and insert the adapter bushing on open end of penile tube.

Steps to using the Rejoyn Vacuum Therapy System

1. Lubricate your penis, the inside of the penile tube, and pubic area (the area that comes in contact with the adapter bushing) with water soluable lubricant. This helps form a good vacuum seal at your body and prevents the penis from sticking to the walls of the tube.
2. Insert the penis into the penile tube and start the vacuum process. Operate the pump by pulling and pushing the handle. Each time you pull the handle back (about a 2 inch stroke) you create vacuum in the penile tube.
NOTE: Three to five strokes should create a low level vacuum enough to create a seal between the system and your body. Continue pulling and pushing the handle an additional five to seven times to develop the vacuum.
3. As soon as desired erection is achieved, transfer ring onto base of the penis with fingertips. Make sure ring is transferred all the way around.
NOTE: Pushing the manual release button can release any vacuum that is left! Practice a few times without the constriction ring.
4. You should not wear the constriction ring more than 30 minutes. To remove the ring, pull outwared on the side tabs. The ring will stretch allowing you to pull it off easily.
NOTE: To prevent tangling the contriction ring in the pubic hair, try a little lubricating jelly in the hair before putting on the ring.
5. Following intercourse, wash, dry and return the ring to its plastic bag. Make sure the bag is air free and tightly sealed for longer life. DO NOT EVER PUT THE PUMPHEAD IN WATER. THIS WILL CAUSE DAMAGE TO THE PUMP.

How to use the vacuum release button

The vacuum release button can be pushed to lower vacuum level. If too much vacuum is released, it can be easily increased by pulling and pushing the handle.
To remove your penis from the tube, push the release valve until vacuum pressure is gone. Then remove the tube from your penis. If you find that you are keeping enough of an erection for intercourse, you may not need to use a constriction ring.
Most men with a problem will lose their erection soon after removing their penis from the vacuum tube. This problem can be solved by correctly fitting the constriction ring. Your penis should become filled and rigid without pain in 10 to 90 seconds. You may feel pressure when your penis starts to become erect from the vacuum. This is normal.
If you feel slight pain when your penis becomes filled, try a lower vacuum by pushing the release button. (With a little practice you should find your correct vacuum so that you can create a full erection without pain.)


Return to top

Rejoyn Support Sleeve

How to Use the Rejoyn Support Sleeve

How to Use Rejoyn 1. Fit the Rejoyn sleeve over the penis with the open side facing down. The sleeve may or may not cover the head of the penis.
2. Snug the sleeve comfortably up against the pelvic bone and wrap the strap around the scrotum.
3. Fasten the sleeve in place by threading the strap through the locking mechanism.
NOTE: The strap on the disposable sleeve is designed to break away for easy removal. Adjust it carefully. Do not over-tighten the strap or attempt to loosen it after it is secure.
4. After the sleeve is comfortably in place, roll the lubricated Comfort Cover over the sleeve. If desired, the end of the cover may be pulled back ot expose the head of the penis. The specially designed open-ended covers allow greater sensitivity for men and lubricated comfort for women.
5. The Rejoyn Support Sleeve and Comfort Cover are disposable. To remove the sleeve, simply pull the end of the strap upward and toward your left until it breaks away.

TIPS for USING the REJOYN SUPPORT SLEEVE

For best results, always use Rejoyn brand Comfort Covers™. They offer additional support for the sleeve and lubrication for women. NOTE: You may want to use additional lubrication, a water soluble lubricant can be applied to the cover.
Rejoyn support sleeves are available in other sizes to fully accommodate the comfort and preferences of men and women. If the size you've purchased doesn't feel right, simply order a different size.
You may need to practice until you and your partner get used to the sleeve. It is generally best to let the woman control the pace and motion.
If you or your partner feel any discomfort with the Rejoyn Support Sleeve, stop immediately. You may want to try a different size or use a water-soluble lubricant in addition to the Comfort Cover.

Return to top

Endure Climax Control Sleeve

How to Use Endure How to Use the Endure sleeve

1. Fit the Endure sleeve over the erect penis with the open side facing down. The sleeve may or may not cover the head of the erect penis.
2. Snug the sleeve comfortably up against the pelvic bone and wrap the strap around the scrotum.
3. Fasten the sleeve in place by threading the strap through the locking mechanism.
Note: The strap is designed to break away for easy removal. Adjust it carefully. Do not over-tighten the strap or attempt to loosen it after it is secure.
4. After the sleeve is comfortably in place, roll the lubricated Comfort Cover over the sleeve. If desired, the end of the cover may be pulled back to expose the head of the penis. The specially designed opn-ended covers allow some sensitivity for men and lubricated comfort for women.
5. The Endure sleeve and Comfort Cover are disposable. To remove the sleeve, simply pull the end of the strap upward and toward your left until it breaks away.

TIPS for using the Endure Climax Control Sleeve

For best results, always use the lubricated Comfort Covers. They offer additional support for the sleeve and lubrication for women.
Note: You may want to use additional lubrication. A water soluble lubricant can be applied to the Comfort Cover.


Return to top

Rejoyn Support RingHow to Use the Constriction Ring

How to Use the Rejoyn Support Ring

1. Completely lubricate the cone. Grip each tab and press the constriction ring down over the cone onto the loading sleeve, using your thumbnail.
2. Separate the cone from the loading sleeve.
3. Slip the loading sleeve over the penis with the ring stop facing out, away from your pelvic bone, slide away from your pelvic bone, slide the ring off the loading sleeve onto the base of your penis as close to your pelvic bone as possible.
4. The support ring should grip the base of your penis comfortably.
NOTE: If you get a good, firm erection and then it slowly goes down, you may need to use a smaller constriction ring.
5. To remove the ring, pull outward on the side tabs.
NOTE: After using the ring, wash, dry and return ring to its plastic bag. Make sure the bag is air free and tightly sealed for longer life.

TIPS for USING

Rejoyn Support Rings are available in 4 (four) different sizes. Choose the size that best fits you. If you get a good, firm erection, but it slowly goes down, you may need to use a smaller constriction ring.
The support ring should grip the base of your penis to ensure a good fit and to maintain a good erection.
If you or your partner feel any discomfort with the support ring, stop immediately. You may want to try a different size ring.


Return to top

Online ordering through CyberWorld Marketing, LLC

If you are often or always unable to achieve a sufficient erection for sexual intercourse, consult your doctor promptly to avoid a potentially harmful delay in diagnosing the cause of your condition (impotence).

Endure is a trademark of Gain, Inc.
Rejoyn is a licensed trademark of Pos-T-Vac, Inc.
This site is © 1999-2006 CyberWorld Marketing, LLC. All rights reserved.